Genie TMZ-10 Bedienungsanleitung PDF herunterladen (Seite 29)

Part No. 72896 Genie TMZ-50/30 & Genie TMZ-17/10 27

Operator's Manual

First Edition • Third Printing

OPERATING INSTRUCTIONS

Battery and Charger Instructions

Observe and Obey:

Do not use an external charger or booster

battery.

Charge the battery in a well-ventilated area.

Use proper AC input voltage for charging as

indicated on the charger.

Use only Genie authorized battery and charger.

To Charge Battery

1 Be sure the batteries are connected before

charging the batteries.

2 Open the turntable covers. The covers should

remain open for the entire charging cycle.

3 Remove the battery vent caps and check the

battery acid level. If necessary, add only

enough distilled water to cover the plates. Do

not overfill prior to the charge cycle.

4 Replace the battery vent caps.

5 Connect the battery charger to a grounded AC

circuit.

6 Turn the battery charger on.

7 The charger will indicate when the battery is

fully charged.

8 Check the battery acid level when the charging

cycle is complete. Replenish with distilled water

to the bottom of the fill tube. Do not overfill.

Dry Battery Filling and

Charging Instructions

1 Remove the battery vent caps and permanently

remove the plastic seal from the battery vent

openings.

2 Fill each cell with battery acid (electrolyte) until

the level is sufficient to cover the plates.

Do not fill to maximum level until the battery charge

cycle is complete. Overfilling can cause the battery

acid to overflow during charging. Neutralize battery

acid spills with baking soda and water.

3 Install the battery vent caps.

4 Charge the battery.

5 Check the battery acid level when the charging

cycle is complete. Replenish with distilled water

to the bottom of the fill tube. Do not overfill.

Voltage Conversion

Some battery chargers are equipped with a

multifunction fuse, which enables the operator to

switch between 110-120 volts and 220-240 volts.

1 Locate the fuse drawer

module on the front of the

battery charger.

2 To change voltage, pull the fuse drawer out, flip

it over so the desired voltage range reads right

side up, and return the drawer to the slot.

3 Check that the triangle

next to the desired

voltage range points to

the triangle printed on

the lip of the module.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34

Kommentare zu diesen Handbüchern

Keine Kommentare

Genie TMZ-10 Bedienungsanleitung Seite 29

Kommentare zu diesen Handbüchern